Bostik overpaintable wood sealant 300 ml d2617
The high-quality sealant for closing joints and cracks in wood, parquet and laminate floors. Perfect for sealing joints, joints and holes of all kinds around wood, such as connecting joints between walls, steps, radiator pipes and the like, especially in places where it is not possible to apply skirtings.
Characteristics:
- Paintable
- Easily usable
- Ready to use
- Long-lasting electroplasticity (max. 12.5% elasticity)
- Neutral and acid-free
- Extraordinary adhesion without primer
- Resistant to UV rays and atmospheric agents
- Applicable in indoor and outdoor environments
Preparation:
Conditions of use: use at a temperature between +5°C and +40°C.
Surface requirements: the base must be dry, clean and free of dust, grease and rust.
Preliminary surface treatment: for good results, apply a protective tape to the edges of the gap. To prevent three-sided adhesion and to obtain the right sealing depth, fill the joints with a piece of sealing foam or a PE sheet.
Tools: Treat the cartridge with a glue gun (e.g. Bostik Click Gun).
Applications:
Usage: 1 cartridge for an 8 meter gap of 6 x 6 mm.
How to use:
- Remove the plastic ring from the thread.
- Turn the plastic nozzle and cut diagonally to the desired opening.
- The width of the joint must be a minimum of 6 and a maximum of 24 mm.
- The joint can be 6 to 9 mm deep.
- Spray the sealant evenly into the joint and smooth it out within 10 minutes with your fingers or a wet spatula.
Stains/residues: remove wet stains directly with water. The dry product can only be removed mechanically. Make sure the grout stays dry for at least the first 8 hours. Do not apply when it is raining or rain is expected.
Drying times:
Skin time: approx. 15 minutes
Curing time: approx. 1 mm/24 hours
Drying time: approx. 8-14 days for complete drying, depending on ambient relative humidity and temperature.
*Drying time may vary depending on the type of surface, quantity of product used, air temperature or humidity.
Technical features:
- Moisture resistance: good
- Temperature resistance: from -20°C to +80°C
- UV resistance: good
- Mold resistance: no
- Possibility of repainting: very good
- Elasticity: limited
- Filling power: good
Technical specifications:
Base material: acrylate dispersion
Color: Mahogany
Viscosity: approx. 0 mpa.s., pasty
Dry residue: approx. 78%
Density: approx. 1.62 g/cm³
Pickup: approx. 35%
Max. deformation acceptable: approx. 12.5%
